Can my consumer unit handle a heat pump?

A heat pump puts real demands on your electrics. With this checklist you can see a lot yourself — before you ask for a quote.

⚠️ Safety first: the cover of the consumer unit (meterkast) stays closed. Everything below is done by looking and using the buttons meant for you. In doubt, smell burning or feel heat? Switch off and call an electrician.

Step by step

Is your consumer unit heat-pump ready?

Step 1

Is there room for an extra circuit?

A heat pump gets its own circuit. Do you see free spaces in the unit, or is it full?

Step 2

Are all circuits behind an RCD?

Older units sometimes have just one RCD for everything, or none. Then an upgrade is usually needed.

Step 3

How heavy is your connection?

Check whether you have single or three-phase. A hybrid heat pump usually fits on single-phase; an all-electric one sometimes doesn’t.

Step 4

How old is the unit?

Screw-in fuses, discolouring or a unit over 30 years old? Replacing is often smarter than adding.

Good to know

And then?

Hybrid: a smaller heat pump next to your gas boiler, less power needed. All-electric: no more gas, more power and sometimes three-phase.
For a (hybrid) heat pump you can apply for the Dutch ISDE subsidy at RVO if an installation company does all the work. At least € 500 depending on the model; for homes built before 2019.
I check the consumer unit, prepare it and install the heat pump end to end — from design to commissioning.

Read also: Single or three-phase? →  ·  All guides →

Heat pump in your plans?

Send a photo of your consumer unit. You’ll get an honest check quickly, then a fixed-price quote.